Norstar: Programming System Speed Dials

Norstar
April 08, 2013•1 min read

To enter a programming session and set up system speed dials on a Norstar system, follow these steps:

  1. Press FEATURE * * 2 6 6 3 4 4.
  2. Enter password: 2 6 6 3 4 4. The display will read 'Terminals & Sets'.
  3. Press NEXT. The display will read 'Lines'.
  4. Press NEXT. The display will read 'Services'.
  5. Press NEXT. The display will read 'System Speed Dial'.
  6. Press SHOW. The display will read 'Speed dial #:__'. Hint: begin your system speed dials with '01'.
  7. Press SHOW. The display will read 'No number stored'.
  8. Press the CHANGE soft key. The display will read '#01:'.
  9. Enter the speed dial number, then press the OK soft key.
  10. Press NEXT. The display will read 'Use prime line'.
  11. Press NEXT. The display will read 'Display digits:Y'.
  12. Press NEXT. The display will read 'Bypass restr'n:N'.
  13. Press NEXT. Speed dial 01 has now been programmed. To program another speed dial number, repeat the steps from the 'Speed dial #' prompt.

If you have questions or need assistance, call us at (905) 564-3200.

NorstarSpeed DialProgramming
Back to Blog